Seat Track - Second Row, Bucket

SEAT TRACK - SECOND ROW, BUCKET

Removal and Installation

1. Remove the affected rear seat quad bucket from the vehicle.

2. Remove the rear seat quad bucket backrest.







3. Remove the lower anchors and tethers for children (LATCH).
1. Remove the LATCH attachment bolts.
- To install, tighten to 25 Nm (18 lb-ft).

2. Unlatch the J-clips on the LATCH cover.
3. Remove the LATCH.







4. Remove the 4 nuts (2 shown) and the seat support.
- To install, tighten to 25 Nm (18 lb-ft).







5. NOTE: On the RH side seat only, make sure the seat track is in the full rearward position to access the front seat track bolts.

Remove the seat track bolts and remove the seat track assembly.

- To install, tighten to 25 Nm (18 lb-ft).







6. Remove the safety belt buckle end assembly.
1. Remove the safety belt buckle end bolt.
- To install, tighten to 40 Nm (30 lb-ft).

2 Remove the safety belt buckle end.







7. If LH seat, remove the cushion support bracket bolts and the cushion support from the seat cushion frame.
- To install, tighten to 25 Nm (18 lb-ft).

8. To install, reverse the removal procedure.
- Make sure the safety belts and buckles are accessible to the occupants after installation.