Antitheft and Alarm Systems: Description and Operation

ANTI-THEFT

NOTE: If the instrument cluster or the PCM (or both) is installed, the parameters MUST be re-set in both modules or the vehicle will experience a passive anti-theft system (PATS) no-start.

PATS consists of the following components:
- Anti-theft indicator (located in the instrument cluster)
- Encoded (the key contains a transponder) ignition key
- PATS transceiver
- Instrument cluster

PATS uses radio frequency identification technology to deter a drive-away theft. Passive means that it does not require any activity by the user.

The vehicle is equipped with 2 PATS keys. A maximum of 8 PATS keys can be programmed to start the vehicle. If additional PATS keys are desired, refer to Spare Key Programming - Unlimited Key Mode. Unlimited Key Mode

PATS Function
The PATS function is controlled by the instrument cluster. The PATS uses the instrument cluster to carry out all of the PATS functions such as receiving the identification code from the PATS key, issuing a signal to the powertrain control module (PCM) to control the starter and fuel injectors enable, and initiates the key interrogation sequence when the ignition key is turned to the ON or START position. Because of the interaction between the instrument cluster and the PCM, there are parameters that must be set if the instrument cluster or the PCM (or both) are replaced. If the instrument cluster must be replaced for any reason (PATS concerns or driveability concerns), the PATS keys also must be programmed into the new instrument cluster. All elements of PATS must be functional before the vehicle will start. If any of the components are not working correctly, the vehicle will not start.

PATS is active only for a few seconds when the vehicle is starting. It is not a PATS concern if the vehicle stalls after it has been running for a minimum of 3 seconds. PATS will not disable a running vehicle.

PATS is not compatible with aftermarket remote start systems, which allow the vehicle to be started from the exterior of the vehicle. These systems may reduce the security of the vehicle, and also may be the cause of no-start concerns. Remote start systems must be removed from the vehicle before any PATS-related no-start concerns are investigated.

Unlimited Key Mode
PATS contains a feature called unlimited key mode. This feature allows a customer to program more than 8 vehicle keys, if requested. Each vehicle in unlimited key mode is set up with a special unlimited transponder security key code. This allows all the customer vehicles to share the same mechanically cut keys. For an individual customer, any randomly selected security key is acceptable.