Seat Backrest - Second Row, 20 Percent

SEAT BACKREST - SECOND ROW, 20 PERCENT

Part 1:

Part 2:

Disassembly and Assembly
1. Remove the 20 percent seat.
2. Remove the 20 percent seat backrest.
3. Remove the safety belt guide cover.
- Insert an appropriate tool into the holes and release the 3 locking tabs.
- Detach the safety belt guide cover.
- Route the safety belt webbing through the slot.

4. Remove the latch release handle bezel.
- Release the upper tab and separate the bezel from the latch release handle.

5. CAUTION: Use care when separating the backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the backrest foam pad.

Separate the hook-and-loop strips and invert the backrest trim cover to the row of hog rings.

6. Remove the row of hog rings.
7. Continue inverting and remove the backrest trim cover.
- Route the safety belt webbing through the trim cover opening.

8. Remove the 2 pin-type retainers and foam pad.
9. Remove the safety belt retractor foam cover.
10. Remove the 2 screws and safety belt retractor cover.
11. Remove the safety belt retractor bolt.
- To install, tighten to 40 Nm (30 lb-ft).







12. Release the 2 tabs and detach the safety belt retractor guide.

13. NOTE:
- Note safety belt routing for installation.
- Make sure the safety belt webbing is not twisted prior to installation.

Remove the safety belt retractor.
- Route out the safety belt webbing, guide, tongue and anchor through the backrest frame.

14. Release the pin-type retainer and detach the release cable from the backrest frame.

15. NOTE: Note cable routing for installation.

Remove the 2 screws and latch release handle.
- Route out the release cable.

16. Remove the 2 pin-type retainers and 2 attaching straps.
17. Remove the 8 backrest support panel screws.
18. To assemble, reverse the disassembly procedure.
- Verify the safety belt retractor operates without excessive effort or binding.