Seat Track - Power

SEAT TRACK - POWER

Seat Backrest - Front, 40 Percent (Part 1):

Seat Backrest - Front, 40 Percent (Part 2):

Seat Cushion - Front, 40 Percent (Part 1):

Seat Cushion - Front, 40 Percent (Part 2):

Seat Cushion - Front, 60 Percent (Part 1):

Seat Cushion - Front, 60 Percent (Part 2):

Exploded View

Removal and Installation

WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

All seats
1. Remove the affected seat and depower the supplemental restraint system (SRS).
2. Remove the seat backrest.







3. Remove the safety belt buckle pretensioner.
- Remove the tie strap.
- Disconnect the 2 electrical connectors.
- Remove the nut and safety belt buckle pretensioner.
- To install, tighten to 55 Nm (41 lb-ft).

4. Release the cushion trim cover front and rear J-clips and rear hook-and-loop strip.

Climate controlled seats







5. NOTE:
- Use care when removing the thermo-electric device (TED). The U-nuts can slip into the cushion frame.
- Note wiring harness routing for installation.

Remove the climate controlled seat thermo-electric device (TED).
- Disconnect the electrical connector.
- Detach the pin-type retainer and wiring harness.
- Remove the 2 screws.
- Route the wiring harness and remove the TED.







6. Release the 2 tabs and slide out the climate controlled seat module (CCSM).







7. NOTE: When installing a new climate control seat module (CCSM), it is necessary to carry out programmable module installation (PMI).

If passenger seat, remove the CCSM.
- Cut and remove the wiring harness tie strap.
- Release the 2 locking wedges.
- Disconnect the 3 electrical connectors.

Driver memory seat







8. Remove the driver seat module (DSM).
- Disconnect the 5 electrical connectors.
- Release the 2 tabs and slide out the DSM.

All seats
9. Remove the cushion frame, foam pad and trim cover assembly from the seat track.
- Remove the 4 cushion frame-to-seat track bolts.
- To install, tighten to 25 Nm (18 lb-ft).

- Release the 2 cushion frame rear clips and straps from the seat track and remove the cushion frame.

10. Disconnect the seat track motor electrical connector.
- For 6-way power seat, disconnect the 3 motor electrical connectors.
- For memory seat, disconnect the 6 motor electrical connectors.

11. NOTE: Note wiring harness routing for installation.

Remove the wiring harness.
- Remove the 3 wiring harness bracket screws.
- Remove the tie strap and release the rear wiring harness bracket clip from the seat track.
- Separate the electrical connectors and wiring harness from the seat track.
- Route and remove the wiring harness and bracket.

12. To install, reverse the removal procedure.
13. Install the seat backrest.
14. Install the seat and repower the SRS.