Seat - Front, 60 Percent

SEAT - FRONT, 60 PERCENT

Removal







WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a SRS fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Position the seat to access all seat-to-floor fasteners.
2. Depower the supplemental restraint system (SRS).
3. Remove the front seat cushion panel shield.
4. Remove the seat-to-floor front bolt cover.
5. Remove the 2 seat-to-floor front bolts.







6. Detach the pin-type retainer and vehicle wiring harness from the seat.
7. Disconnect the seat harness electrical connectors.
- Disconnect the safety belt buckle pretensioner electrical connector.
- Slide the release button and separate the connector.

- Disconnect the side air bag electrical connector.
- Slide the release button and separate the connector.

- Disconnect the seat harness electrical connector.
- Release the locking tab and rotate the assurance lever fully to disengage the seat harness electrical connector.
- Slightly tip the connector away and disconnect.

8. Remove the 2 seat-to-floor rear bolt covers.
9. Remove the 2 seat-to-floor rear bolts.
10. Remove the center seat safety belt buckle bolt cover and bolt.
11. Remove the seat from the vehicle.

Installation

NOTE: The seat-to-floor bolts must be tightened in the sequence described in this procedure.

1. Position the seat in the vehicle.
2. Install the inboard seat-to-floor rear bolt and bolt cover.
- Tighten to 40 Nm (30 lb-ft).

3. Install the outboard seat-to-floor front bolt and bolt cover.
- Tighten to 40 Nm (30 lb-ft).

4. Install the inboard seat-to-floor front bolt.
- Tighten to 40 Nm (30 lb-ft).

5. Install the outboard seat-to-floor rear bolt and bolt cover.
- Tighten to 40 Nm (30 lb-ft).

6. Position the center seat safety belt buckle and install the bolt.
- Make sure the safety belt webbing is not twisted prior to installation.
- Tighten to 40 Nm (30 lb-ft).

7. Install the center seat safety belt buckle bolt cover.
8. Connect the electrical connectors.
- Connect the seat harness electrical connector.
- Make sure the electrical connector assurance lever is in the fully released position.
- Tip the body harness connector into the seat connector and partially insert.
- Rotate the assurance lever while pushing the connectors together until the handle is locked.

- Connect the safety belt buckle pretensioner electrical connector.
- Make sure the release is locked.

- Connect the side air bag electrical connector.
- Make sure the release is locked.







9. Install the wiring harness pin-type retainer.
10. Install the front seat cushion panel shield.
11. Repower the SRS.
12. Make sure the safety belts and buckles are accessible to the occupants after installation.