Seat - Second Row, 40 Percent

SEAT - SECOND ROW, 40 PERCENT







Removal

All seats
1. Place the seat in the E-Z entry position.
2. Remove the cover and 2 seat-to-floor rear bolts.

3. NOTE: Do not place the seat in the kneeled position (cargo mode).

Latch the seat to the floor and lower the backrest.







4. CAUTION: The seat base must be in the locked position, using the shipping pin, prior to seat removal, otherwise damage to the seat linkage components can occur.

NOTE: Shown with the cushion removed for clarity.

Lock the shipping pin.
- Using an appropriate tool, slide the shipping pin outward to engage and lock the seat base.
- Align the seat base and shipping pin, as needed.

5. Remove the cover and 2 seat-to-floor front bolts.
6. Pull the recliner handle and release the latch feet.

Seat with inoperative latch, stuck to floor







7. Using an appropriate tool, manually release the latches from the striker plate.
- Push inward on the outboard latch release lever.

All seats
8. Lift to disengage the 2 locator pins and remove the seat.

Installation
1. Position the seat in the vehicle.
- Align the 2 locator pins to the floor holes.
- Press downward and lock the latch feet to the floor.

2. Install the 2 seat-to-floor front bolts.
- Tighten to 40 Nm (30 lb-ft).

3. Install the seat-to-floor bolt front cover.







4. Using an appropriate tool, push the shipping pin fully inward to unlock the seat from the E-Z entry position.
5. Release the seat to the E-Z entry position.
6. Install the 2 seat-to-floor rear bolts.
- Tighten to 40 Nm (30 lb-ft).

7. Install the seat-to-floor rear bolt cover.
8. Check the seat for correct operation.
- With the seat in the upright or the load floor position, both latch feet must lock to the strikers.
- When releasing the seat to the E-Z entry position, the latches must release freely and not bind to the strikers.
- Make sure the safety belts and buckles are accessible to the occupants after installation.