Front

Wheel Hub





Removal and Installation

CAUTION: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

1. Disconnect the wheel speed sensor electrical connector.





2. With the vehicle in NEUTRAL, position it on a hoist.
3. Remove the wheel speed sensor harness bracket bolt and detach the harness from the retainers.
^ To install, tighten to 12 Nm (9 lb-ft).





4. CAUTION: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose can result.

Remove the bolts and position the caliper and anchor plate aside.
^ Support the caliper using mechanic's wire.
^ To install, tighten to 200 Nm (148 lb-ft).
5. Remove the brake disc.
6. Remove the 4 wheel bearing and wheel hub assembly bolts and the wheel bearing and wheel hub.
^ To install, tighten to 150 Nm (111 lb-ft).
7. If installing a new wheel bearing and wheel hub, remove the wheel speed sensor bolt and the wheel speed sensor.
^ To install, tighten to 18 Nm (13 lb-ft).

8. CAUTION: If the original wheel bearing and wheel hub is being installed, install a new wheel bearing and wheel hub assembly O-ring seal.

To install, reverse the removal procedure.