Side Impact Sensor - C-Pillar

SIDE IMPACT SENSOR - C-PILLAR







Removal and Installation

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- Vehicle sensor orientation is critical for correct system operation. If a vehicle equipped with an air bag SRS is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Install and correctly position the sensor or any other damaged SRS components whether or not the air bag is deployed.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a SRS fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
- RH side shown, LH similar.

1. Depower the system.
2. Remove the rear door scuff plate.
3. Detach the rear door weatherstrip.

4. NOTE: Make sure the second row safety belt retractor belt webbing is not twisted prior to installation.

Remove the bolt and second row safety belt retractor anchor.
- To install, tighten to 40 Nm (30 lb-ft).

5. Position aside the quarter trim panel.
- Pull out on the quarter trim panel at the C-pillar to release the retaining clips to access the C-pillar side impact sensor.

6. WARNING: The tightening torque of the side impact sensor retaining bolt is critical for correct system operation.

NOTE:
- Note the position of the side impact sensor locating tab for installation.
- Make sure the C-pillar and side impact sensor mating surfaces are clean and free of foreign material.

Remove the side impact sensor bolt.
- To install, tighten to 11 Nm (8 lb-ft).

7. Disconnect the electrical connector and remove the side impact sensor.
8. To install, reverse the removal procedure.
9. Repower the system.