Ride Height Sensor: Service and Repair

Suspension Height Sensor

LH Side:

RH Side:

Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the senor harness from the sensor bracket.
3. Disconnect the sensor electrical connector.
4. Disconnect the sensor arm from the ball stud on the lower control arm.
5. Remove and discard the 2 sensor bolts.
^ To install, tighten to 11 Nm (8 lb-ft).

6. NOTE: The RH and LH height sensor assemblies cannot be used on opposite sides of the vehicle.

To install, reverse the removal procedure.
7. Calibrate the LH and RH height sensors.