Compressor/Pump: Service and Repair

Air Suspension Compressor





Removal and Installation
1. Remove the inner fender splash shield.
2. Disconnect the air line from the compressor drier.
^ Compress the quick connect lock ring inward, then pull the line outward from the air drier.
3. Disconnect the air compressor air intake hose.
4. Disconnect the air compressor electrical connector.
5. Remove the 3 air compressor bracket bolts and remove the air compressor and bracket assembly.
^ To install, tighten to 15 Nm (11 lb-ft).

6. NOTE: When installing the air lines, make sure the white inner air line is fully inserted into the fitting for correct installation.

NOTE: Make sure that there are no objects trapped under or on the bracket.

Make sure that the air compressor is not in contact with any surrounding components that could cause vibration noises.

NOTE: Make sure that the air compressor moves freely in the rubber isolators.

Make sure that the bracket has no deformations that could cause the 3 rubber isolators to load against each other.

To install, reverse the removal procedure.