Transmission Fluid Level Check
Transmission Fluid Level CheckSpecial Tool(s):
Material:
CAUTION: The vehicle should not be driven if the fluid level is low as internal failure could result.
CAUTION: The fluid fill plug is located near the exhaust system. The exhaust will be extremely hot during this procedure.
NOTE: If the vehicle has been operated for an extended period at high highway speeds, in city traffic, during hot weather or while pulling a trailer, the fluid must cool down to obtain an accurate reading.
NOTE: If the transmission starts to slip, shifts slowly or shows signs of fluid leaking, the fluid level should be checked.
NOTE: Do not overfill the transmission. The fluid level must be at the upper level of the crosshatch mark.
NOTE: If the installation of a new transmission fluid cooler, cooler lines have been carried out the vehicle must be driven to get the transmission fluid to a temperature of 88°C (190°F) in order to purge the air from the cooling system.
1. With the engine running, place the transmission selector lever in each gear position and hold approximately 5 seconds. Place the transmission selector lever in PARK.
2. With the engine idling (600-750 rpm) in PARK, position it on a hoist.
3. Remove the fluid fill plug fluid level indicator assembly, located on the passenger side front portion of the transmission case.
4. Separate the fluid level indicator from the fill plug.
5. Wipe the fluid level indicator clean. Reinstall the fluid level indicator only back into the fill plug hole to check the fluid level.
6. Using the scan tool, verify that the transmission fluid temperature is between 80°C-85°C (175°F-185°F). Do not overfill the transmission. The fluid level must be at the upper level of the crosshatch mark.
7. NOTE: If the transmission fluid is not at the correct level, follow the steps for Adding Additional Transmission Fluid or Removing Transmission Fluid.
Install the fluid fill plug.
^ Tighten to 35 Nm (26 lb-ft).
