Front Door Window Regulator: Service and Repair
WINDOW REGULATOR-FRONT DOORPart 1:
Part 2:
Exploded View
Removal and Installation
NOTE: For Navigator, the LF/RF door power window regulator motor must be reinitialized whenever the LF/RF window regulator is removed from the vehicle.
1. Remove the front door trim panel.
2. Unlock the tabs and remove the window control switch from the door trim panel.
3. Remove the screws and the front door speaker.
- Disconnect the electrical connector.
4. Remove the front door weathershield.
5. Re-connect the electrical connectors to the window control switch.
6. Lower the window glass to access the 2 window glass clamp bolts.
7. Loosen the window glass clamp bolts.
- To install, raise the window glass until it stalls in the UP position. Tighten the window glass clamp bolts to 11 Nm (8 lb-ft).
8. NOTE: Secure the front window glass in the full UP position.
Secure the front window glass with tape to the front door frame.
9. Position the interior door handle aside.
1 Remove the cable conduit fitting from the carrier assembly.
2 Lift upward on the interior door handle retaining bracket and pivot the interior door handle out of the bracket.
3 Remove the cable from the door handle.
10. Release the crash sensor harness pin-type retainers.
11. Position the front door window regulator harness aside.
1 Disconnect the electrical connectors.
2 Release the pin-type retainers.
12. Remove the front window regulator.
1 Loosen the 2 hanger bolts.
2 Remove the front window regulator bolts and front top run channel bolt.
- To install, tighten to 11 Nm (8 lb-ft).
13. To install, reverse the removal procedure.
14. For Navigator, reinitialize the LF/RF window regulator motor.