Seat Backrest - Second Row, 20 Percent

SEAT BACKREST - SECOND ROW, 20 PERCENT

Seat Backrest - 20 Percent (Part 1):

Seat Backrest - 20 Percent (Part 2):

Seat Cushion - 20 Percent (Part 1):

Seat Cushion - 20 Percent (Part 2):

Seat Backrest - 40 Percent:

Seat Cushion - 40 Percent Seat (Part 1):

Seat Cushion - 40 Percent Seat (Part 2):

Exploded View

Removal and Installation
1. Remove the 20 percent seat from the vehicle.
2. Remove the screw and pivot bolt cover.
- Route the attaching strap through the pivot bolt cover.

3. Release the 2 lower backrest trim cover J-clips.
4. Remove the pin-type retainer and detach the LH side attaching strap.
5. Remove the 2 screws and RH side shield.
- Raise the backrest upright to access and remove the center screw.
- Release the 2 pin-type retainers.

6. NOTE: Note attaching strap routing for installation.

Remove the pin-type retainer and detach the RH attaching strap.

7. Remove the bolt and detach the safety belt retractor anchor.
- To install, tighten to 55 Nm (41 lb-ft).

8. Remove the 2 pin-type retainers and lower panel.







9. Release the 3 lower backrest J-clips and route the RH trim cover flap through the child safety seat lower anchor and tether for children (LATCH) anchor.
10. Detach the 2 J-clips and remove the attaching straps.







11. Detach the cable end and latch release cable from the seat base.

12. CAUTION: Use care when separating the cushion trim cover from the hook-and-loop strip, or the hook-an-loop strip can be torn from the cushion foam pad.

Partially invert the backrest trim cover to access the backrest fasteners.

13. Position aside the foam pad and remove the 2 swivel bolts.
- To install, tighten to 30 Nm (22 lb-ft).

14. Remove the pivot bolt.
- To install, tighten to 55 Nm (41 lb-ft).

15. Remove the 2 backrest-to-cushion bolts.
- To install, tighten to 40 Nm (30 lb-ft).

16. NOTE: Note cable routing for installation.

Remove the seat backrest.
- Route out the latch release cable.

17. To install, reverse the removal procedure.