Seat Backrest Cover - Second Row, 20 Percent

SEAT BACKREST COVER - SECOND ROW, 20 PERCENT

Seat Backrest - 20 Percent (Part 1):

Seat Backrest - 20 Percent (Part 2):

Seat Cushion - 20 Percent (Part 1):

Seat Cushion - 20 Percent (Part 2):

Seat Backrest - 40 Percent:

Seat Cushion - 40 Percent Seat (Part 1):

Seat Cushion - 40 Percent Seat (Part 2):

Exploded View

Removal and Installation
1. Remove the 20 percent seat from the vehicle.
2. Remove the screw and pivot bolt cover.
- Route the attaching strap through the pivot bolt cover.

3. Release the 2 lower backrest trim cover J-clips.
4. Remove the pin-type retainer and detach the LH side attaching strap.
5. Remove the 2 screws and RH side shield.
- Raise the backrest upright to access and remove the center screw.
- Release the 2 pin-type retainers.

6. NOTE: Note attaching strap routing for installation.

Remove the pin-type retainer and detach the RH attaching strap.

7. Remove the bolt and detach the safety belt retractor anchor.
- To install, tighten to 55 Nm (41 lb-ft).

8. Remove the 2 pin-type retainers and lower panel.







9. Release the 3 lower backrest J-clips and route the RH trim cover flap through the child safety seat lower anchor and tether for children (LATCH) anchor.
10. Detach the 2 J-clips and remove the attaching straps.
11. Remove the safety belt guide cover.
- Insert an appropriate tool into the holes and release the 3 locking tabs.
- Detach the safety belt guide cover.
- Route the safety belt webbing through the slot.

12. Remove the latch release handle bezel.
- Release the upper tab and separate the bezel from the latch release handle.

13. CAUTION: Use care when separating the backrest trim cover from the hook-and-loop strip, or the hook-an-loop strip can be torn from the backrest foam pad.

Separate the hook-and-loop strips and invert the backrest trim cover to the row of hog rings.

14. Remove the row of hog rings.
15. Continue inverting and remove the backrest trim cover.
- Route the safety belt webbing through the trim cover opening.

16. To install, reverse the removal procedure.