Seat Backrest Cover - Second Row, 40 Percent

SEAT BACKREST COVER - SECOND ROW, 40 PERCENT

Seat Backrest - 20 Percent (Part 1):

Seat Backrest - 20 Percent (Part 2):

Seat Cushion - 20 Percent (Part 1):

Seat Cushion - 20 Percent (Part 2):

Seat Backrest - 40 Percent:

Seat Cushion - 40 Percent Seat (Part 1):

Seat Cushion - 40 Percent Seat (Part 2):

Exploded View

Removal and Installation







1. NOTE:
- Note the spring clip position for installation.
- Use care when releasing the spring clips. They can fall inside the backrest frame.

Remove the head restraint.
- Pull the trim cover material away from the head restraint guide to access the spring clips.
- Release the 2 spring clips by pushing on the side shown.
- Raise and remove the head restraint.

2. Position the backrest downward.
3. Remove the kneeling release (cargo mode) handle.
- Raise the handle to access the cable.
- Detach the cable jacket from the kneeling release handle.
- Release the retainers and position aside the kneeling release handle.

4. Release the lower backrest trim cover J-clip.







5. Position aside the backrest trim cover rear flap and remove the 4 pin-type retainers.
6. Raise the backrest upright and route the backrest trim cover from between the cushion and backrest.

7. CAUTION: Use care when separating the seat backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the seat backrest foam pad.

Invert the backrest trim cover to the row of hog rings.
- Separate the hook-and-loop strips.

8. Remove the row of hog rings.
9. Continue inverting the backrest trim cover to the head restraint guides.

10. CAUTION: Be careful not to tear the material when separating the head restraints and spring clips from the backrest trim cover.

Pinch the head restraint guide ends to release and remove the 2 head restraint guides.
- Separate the head restraint guides from the backrest trim cover.

11. Remove the backrest trim cover.
12. To install, reverse the removal procedure.