Seat Backrest Cover - Third Row

SEAT BACKREST COVER - THIRD ROW

Seat Backrest - 40 Percent (Part 1):

Seat Backrest - 40 Percent (Part 2):

Seat Cushion - 40 Percent (Part 1):

Seat Backrest - 60 Percent (Part 1):

Seat Backrest - 60 Percent (Part 2):

Seat Cushion - 60 Percent:

Exploded View

Removal and Installation

NOTE: LH seat shown, RH seat similar.

All seats
1. Remove the affected seat.
2. Remove the seat backrest.







3. NOTE:
- Note the spring clip position for installation.
- Use care when releasing the spring clips. They can fall inside the backrest frame.

Remove the head restraint.
- Pull the trim cover material away from the head restraint guide to access the spring clips.
- Release the 2 spring clips by pushing on the side shown.
- Raise and remove the head restraint.

4. Release all the backrest trim cover J-clips.







5. Remove all the staples.

LH seat
6. Release the hook-and-loop strip.
7. Remove the safety belt anchor bolt.
- To install, tighten to 40 Nm (30 lb-ft).

8. Remove the safety belt guide cover.

Manual fold seat

9. NOTE: Note cable routing for installation. Remove the 2 screws and the manual latch handle and cable assembly.
- Route out the cable.

All seats

10. NOTE: The head restraint sleeve pins are not interchangeable. Note location for installation.

Reach up into backrest and squeeze the head restraint guide ends together to release and pull the 2 head restraint guides out.

11. CAUTION: Use care when separating the backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the backrest foam pad.

Separate the hook-and-loop strips and invert the backrest trim cover to the row of hog rings.

12. Remove the row of hog rings.
13. Remove the trim cover.
- For LH seat backrest, route the safety belt webbing through the trim cover.

14. To install, reverse the removal procedure.