Seat Track - Manual

SEAT TRACK - MANUAL

Seat Backrest - Front, 40 Percent (Part 1):

Seat Backrest - Front, 40 Percent (Part 2):

Seat Cushion - Front, 40 Percent (Part 1):

Seat Cushion - Front, 40 Percent (Part 2):

Seat Cushion - Front, 60 Percent (Part 1):

Seat Cushion - Front, 60 Percent (Part 2):

Exploded View

Removal and Installation

WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Remove the affected seat and depower the supplemental restraint system (SRS).







2. Remove the inboard and outboard seat track rails.
- Remove the 6 seat track rail-to-seat track nuts from the inboard and outboard seat track rails.
- To install, tighten to 30 Nm (22 lb-ft).

- Remove the inboard and outboard seat track rails.
- Release and separate the seat track adjust handle from the seat track rails.

- NOTE: Note the spring position for installation.

Disconnect the spring.

- Slightly bend the tab and detach the seat adjust handle from the inboard seat track rail.

3. To install, reverse the removal procedure.
4. Install the seat.
5. Repower the SRS.