Side Impact Sensor - Front Door

SIDE IMPACT SENSOR - FRONT DOOR







Removal and Installation

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- Vehicle sensor orientation is critical for correct system operation. If a vehicle equipped with an air bag SRS is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Install and correctly position the sensor or any other damaged SRS components whether or not the air bag is deployed.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- Avoid applying corrosion protection to any safety, mechanical and electrical parts, electric motors, speakers, door locks and drain holes.
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a SRS fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
- Driver side shown, passenger similar.

1. Depower the system.
2. Remove the front interior door trim panel on the side with the affected side impact sensor.







3. Separate the weathershield from the door enough to access the side impact sensor.
4. Disconnect the side impact sensor electrical connector.

5. WARNING: The tightening torque of the side impact sensor retaining screws is critical for correct system operation.

NOTE:
- Make sure the side impact sensor mating surfaces are clean and free of foreign material.
- Note the position of the side impact sensor locating tab for installation.

Remove the 2 screws and side impact sensor.
- To install, tighten to 3 Nm (27 lb-in).

6. To install, reverse the removal procedure.
7. Repower the system.