Seat Control Switch - Front
SEAT CONTROL SWITCH - FRONTSeat Backrest - Front, 40 Percent (Part 1):
Seat Backrest - Front, 40 Percent (Part 2):
Seat Cushion - Front, 40 Percent (Part 1):
Seat Cushion - Front, 40 Percent (Part 2):
Seat Cushion - Front, 60 Percent (Part 1):
Seat Cushion - Front, 60 Percent (Part 2):
Exploded View
Removal and Installation
WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Driver seat shown, passenger similar.
All seats
1. Position the seat forward and upward to aid in seat control switch removal.
2. Depower the supplemental restraint system (SRS).
3. Pull and remove the seat control switch button(s).
- If equipped, remove the power recliner switch button.
Power seat with manual recliner
4. CAUTION: Do not pull from the inboard side of the front seat cushion panel shield to avoid damaging it.
Remove the front seat cushion panel shield.
- Release the upper retaining clips working from the outboard side and then release the lower retaining clips.
5. Remove the cushion side shield cover forward screw.
6. CAUTION: Do not damage the manual recliner lever when removing the cushion side shield cover.
Remove the cushion side shield cover.
- Partially remove the cover to gain access to the seat control switch.
- Release the retainers and detach the seat control switch from the side shield cover.
- Remove the cushion side shield cover.
All seats
7. Detach and remove the cushion side shield cover.
- Disconnect the seat control switch.
- If equipped, disconnect the memory set switch electrical connector.
8. Release the clips and remove the seat control switch.
9. To install, reverse the removal procedure.
10. Repower the SRS.