Lateral Accelerometer: Service and Repair
Stability Control Sensor ClusterStability Control Sensor Cluster:
Removal and Installation
NOTE: The lateral and longitudinal accelerometer and the roll rate sensor are located within the yaw rate sensor, stability control sensor cluster.
1. Remove the front floor console. For additional information, refer to Console.
2. Disconnect the stability control sensor cluster electrical connector.
3. Remove the 4 bolts and the bracket.
^ To install:
- Tighten the upper bolts to 9 Nm (80 inch lbs.)
- Tighten the lower bolts to 40 Nm (30 ft. lbs.)
4. Remove the 2 bolts and the stability control sensor cluster.
^ To install, tighten to 12 Nm (9 ft. lbs.)
5. To install, reverse the removal procedure.