Part 2

40. Install the park lever actuating plate.
^ Tighten to 10 Nm (89 lb-in).





41. Position a new manual control lever seal in place.





42. Using the special tool, install a new manual control lever shaft seal.





43. Position the manual lever and park rod in place.
^ Push down on the park pawl and slide the park rod in place.





44. Install the manual lever in the case.
1 Slide the manual lever in the case.
2 Position the spacer in place while sliding the manual lever into the spacer.
3 Position the manual valve inner lever while sliding the manual lever and line up the roll pin hole.
4 Install the roll pin.





45. Install the 4 rubber feed tubes for the center support.





46. Install the thermal bypass valve into the case.





47. Install the rubber adapter.





48. CAUTION: Do not touch the electrical connector pins or the exposed solenoid tabs on the transmission control module (TCM). Electrostatic discharge may occur and may cause damage to the mechatronic unit.

NOTE: The mechatronic assembly will not lay flush on the case, this is normal, the retaining bolts will pull the mechatronic assembly down.

Position the mechatronic assembly in place and loosely install the 10 bolts.
1 Align the manual valve and control lever linkage.





49. Tighten the bolts in the sequence shown.
^ Tighten to 8 Nm (71 lb-in).





50. Install new O-rings on the outer shell of the bulkhead electrical connector.





51. CAUTION: Do not touch the electrical connector pins. Electrostatic charge may occur and will cause damage to the mechatronic unit.

With the release tab up, push the outer shell of the bulkhead electrical connector into the transmission.





52. Press down on the tab and lock the outer shell of the bulkhead electrical connector in place.





53. Install a new transmission fluid filter.





54. NOTE: The fluid pan gasket can be reused if not damaged.

Install a new transmission fluid pan gasket, if required.





55. Install the fluid pan and tighten the bolts in a crisscross pattern.
^ Tighten to 12 Nm (9 lb-ft).





56. Install the torque converter.





4WD vehicles
57. Position a new output shaft seal in place.





58. Using the special tool, install the output shaft seal.





RWD vehicles
59. Position the output shaft seal in place.





60. Using the special tool, install the output shaft seal.





61. Install the anti-click washer over the output shaft.
62. Install the output shaft flange.





63. Install a new output shaft flange nut.
^ Tighten to 80 Nm (59 lb-ft).