Front Door Window Glass: Service and Repair

WINDOW GLASS-FRONT DOOR

Part 1:

Part 2:

Exploded View

Removal

NOTE: For Navigator, the LF/RF door power window regulator motor must be reinitialized whenever the LF/RF motor is removed from the vehicle.

1. Remove the front door trim panel.







2. Unlock the tabs and remove the window control switch from the door trim panel.







3. Remove the screws and the front door speaker.
- Disconnect the electrical connector.







4. Remove the front door weathershield.
5. Re-connect the electrical connectors to the window control switch.
6. Lower the window glass to access the 2 window glass clamp bolts.







7. Remove the inside glass weatherstrip.







8. Remove the front door glass channel bolt and position aside the channel.







9. Loosen the window glass clamp bolts and remove the front door window glass.

Installation
1. Install the front window glass but do not tighten the window glass clamp bolts.







2. Position the front door glass channel and tighten the bolt to 11 Nm (8 lb-ft).







3. Install the inside glass weatherstrip.
4. Raise the window glass until it stalls in the UP position. Tighten the window glass clamp bolts to 11 Nm (8 lb-ft).
- For Navigator, the LF/RF door power window regulator motor must be reinitialized whenever the LF/RF motor is removed from the vehicle.

5. Disconnect the window control switch electrical connectors and reinstall the switch into the door trim panel.







6. Install the front door weathershield.







7. Install the front door speaker.
- Connect the electrical connector and install the screws.

8. Install the front door trim panel.