Ignition Coil: Service and Repair

IGNITION COIL







Exploded View

Removal and Installation
1. Disconnect the ignition coil electrical connector.
2. Disconnect the radio noise suppressor electrical connector.

3. NOTE: Spark plug wires must be connected to the correct ignition coil terminal.

Squeeze the tabs and twist, while pulling upward to disconnect the 6 spark plug wires from the ignition coil.

4. Remove the 4 bolts and the ignition coil.
- To install, tighten to 6 Nm (53 lb-in).

5. NOTE: Apply silicone dielectric compound to the inside of the ignition coil boots.

To install, reverse the removal procedure.