Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) ModuleMaterial:
Removal and Installation
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
CAUTION: Electronic modules are sensitive to electrical charges. The ABS module can be damaged if exposed to these charges.
NOTE: When installing a new ABS module, it must be configured (using vehicle as-built data) and calibrated. Follow the scan tool directions for the calibration procedures. For module configuration, refer to Information Bus.
1. Remove the hydraulic control unit (HCU).
2. CAUTION: Make sure that the ABS module is properly seated to the HCU and that the torque of the ABS module screws is correct, or damage to the components can occur.
Remove the 4 screws and the ABS module.
^ To install, tighten to 2 Nm (18 inch lbs.).
3. To install, reverse the removal procedure.