Seat Temperature Control Module: Service and Repair

HEATED SEAT MODULE

Front Seat Backrest - With Seat Integrated Restraints (SIR):

Front Seat Backrest - Without Seat Integrated Restraints (SIR):

Front Seat Cushion - Driver (Part 1):

Front Seat Cushion - Driver (Part 2):

Front Seat Cushion - Passenger (Part 1):

Front Seat Cushion - Passenger (Part 2):

Exploded View

Removal and Installation

WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Remove the seat and depower the SRS.
2. Disconnect the heated seat module electrical connector.
3. Detach and remove the heated seat module from the seat cushion pan.
4. To install, reverse the removal procedure.
5. Install the seat and repower the SRS.