Exhaust Manifold - RH
Exhaust Manifold - RHMaterial:
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the starter.
3. Remove the RH inner fenderwell.
4. Remove the 2 exhaust Y-pipe flange nuts and position the exhaust Y-pipe flange aside.
5. Remove and discard the 8 exhaust manifold nuts.
6. Remove the RH exhaust manifold and discard the gasket.
7. Remove and discard the 8 exhaust manifold-to-cylinder head studs.
8. Inspect the exhaust manifold for flatness.
Installation
1. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs, or other abrasive means to clean the sealing surfaces. These may cause scratches and gouges resulting in leak paths. Use a plastic scraper to clean the sealing surfaces.
Clean the sealing surfaces with metal surface prep.
2. Install 8 new exhaust manifold-to-cylinder head studs.
^ Tighten to 12 Nm (9 ft. lbs.).
3. NOTE: Install a new exhaust manifold gasket and new nuts.
Position the gasket and the RH exhaust manifold and tighten the nuts in the sequence shown.
^ Tighten to 25 Nm (18 ft. lbs.).
4. Position the Y-pipe flange and install the 2 nuts.
^ Tighten to 40 Nm (30 ft. lbs.).
5. Install the RH inner fenderwell.
6. Install the starter.