Headlamp: Service and Repair

HEADLAMP ASSEMBLY







Removal and Installation

NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

1. Remove the radiator side air deflector.
- Remove the pin-type retainer.

2. Remove the 3 bolts.
- To install, tighten to 5 Nm (44 lb-in).

3. Lift up on the retaining tab and pull the headlamp assembly straight out to prevent damage to the retainer and the locator pin.
- Disconnect the electrical connectors.

4. To install, reverse the removal procedure.