Body - Slow Power Window Operation
TSB 07-2-602/05/07
POWER WINDOW SLOW UPWARD TRAVEL
FORD:
2005-2007 F-150
LINCOLN:
2006-2007 Mark LT
ISSUE
Some 2005-2007 F-150 and 2006-2007 Mark LT vehicles equipped with power windows may experience a customer concern of slow power window travel when raising the window; it may be due to a concern with the alignment of the window glass.
ACTION
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
1. Lower the window completely, and measure the amount of time it takes for the glass to travel from the fully open to fully closed position.
a. If the time is less then six (6) seconds then DO NOT perform this TSB.
b. If the time required to move the glass from the fully open to fully closed position is greater than six (6) seconds, continue with this TSB.
2. Inspect the glass runs to make sure they are not wavy and causing additional resistance to the glass.
3. Remove the door panel following Workshop Manual (WSM), Section 501-05, access the glass clamps through the openings in the door sheet metal. (Figure 1)
4. Loosen the glass clamps (using a 1/4" drive T-30 Torx socket).
5. After loosening the glass clamps, the glass should be pushed up into the header, by hand, then shifted rearward, until it stops against the rear window run seal, and then lowered back into the clamps. (Figure 2)
NOTE
MAKE SURE THE WINDOW IS STATED IN THE BOTTOM OF THE GLASS CLAMPS. TIGHTEN BOTH CLAMPS AND VERIFY PROPER WINDOW PERFORMANCE, BY AGAIN TIMING GLASS CLOSING SPEED.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
OPERATION DESCRIPTION TIME
070206A 2005-2007 F-150, 0.6 Hr.
2006-2007 Mark LT: Align
Front Door Glass, Includes
Time To Remove And
Install Interior Door Trim
Panel: ONE FRONT
DOOR (Do Not Use With
23943A, 23943A1,
23943A2, 23943A4,
23943A14, 22600A)
070206B 2005-2007 F-150, 1.1 Hrs.
2006-2007 Mark LT: Align
Front Door Glass, Includes
Time To Remove And
Install Interior Door Trim
Panel: BOTH FRONT
DOORS (Do Not Use With
23943A, 23943A1,
23943A2, 23943A4,
23943A14, 22600A)
DEALER CODING
CONDITION
BASIC PART NO. CODE
7021410 07
Disclaimer