Test A: Shift and Torque Converter Clutch Solenoids

Pinpoint Tests-OSC Equipped Vehicle

Special Tool(s):

Any time an electrical connector or solenoid body is disconnected, inspect the connector for pin condition, corrosion and contamination. Also inspect the connector seal for damage. Clean, repair or install a new connector or component as required.

Shift Solenoids Pre-Diagnosis
Use the following shift solenoid operation information when carrying out Pinpoint Test A.

Solenoid Operation Chart:

Shift Solenoid Failure Mode Chart "Always Off"
Failed off due to powertrain control module and or vehicle wiring concerns, shift solenoid electrically or hydraulically stuck off.

















Shift Solenoid Failure Mode Chart "Always On"
Failed on due to powertrain control module and or vehicle wiring concerns, shift solenoid electrically or hydraulically stuck on.





TEST A: SHIFT AND TORQUE CONVERTER CLUTCH SOLENOIDS

NOTE: Read and record all DTCs. All Digital TR Sensor and VSS DTCs must be repaired before entering Output State Control (OSC).

NOTE: Refer to the Transmission Internal Harness illustration.

NOTE: Refer to the Transmission Vehicle Harness Connector illustration.

A1:

A1-A5:

A5-A6:

A6-A7:

A8-A9:

A9: