Door Latch Remote Control - SuperCab

DOOR LATCH REMOTE CONTROL - SUPERCAB

Removal and Installation
1. Remove the rear speaker.
2. Position the watershield aside.
3. Remove 3 upper rear door latch screws.
- To install, tighten to 12 Nm (9 ft. lbs.).

4. Remove 3 lower rear door latch screws.
- To install, tighten to 12 Nm (9 ft. lbs.).

5. CAUTION: When drilling out the latch remote control rivets, do not oversize the holes in the door sheet metal. Make sure not to exceed a 6.35 mm (0.25 in) drill bit.

Remove the rear door latch remote control.
1 Disconnect the actuating rods.
2 Remove the rivets.

6. To install, reverse the removal procedure.