Camshaft Position Sensor: Service and Repair

CAMSHAFT POSITION (CMP) SENSOR







Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.

2. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.

Turn the ignition switch to the OFF position.

3. Rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the power steering pump pulley.







4. Remove the 3 bolts and position the power steering pump aside.
- To install, tighten to 25 Nm (18 lb-ft).

5. NOTE: The camshaft position (CMP) sensor is located behind the power steering pump.

Disconnect the CMP sensor electrical connector.

6. Remove the bolt, the CMP sensor and discard the O-ring seal.
- To install, tighten to 13 Nm (10 lb-ft).

7. NOTE: Apply clean engine oil to the new O-ring seal prior to installation.

To install, reverse the removal procedure.
- Install a new O-ring seal.
- Verify that the accessory drive belt is correctly seated on the pulleys.