Transmission Fluid Cooler Tubes - Manual Transmission
Transmission Fluid Cooler Tubes - Manual TransmissionMaterial:
Transmission Fluid Cooler Tubes - Manual Transmission:
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the cooler tube bracket and nut, then the fluid cooler tube bracket. Separate the fluid cooler tube bracket from the tubes.
^ To install, tighten to 10 Nm (89 inch lbs.).
3. Disconnect, and remove each fluid cooler tube, as necessary.
^ To install, tighten to 27 Nm (20 ft. lbs.).
4. To install, reverse the removal procedure.
^ Fill the transmission with clean automatic transmission fluid.
^ Check for leaks.