Heated Seat Switch - With Seat Integrated Restraints (SIR)

HEATED SEAT SWITCH - WITH SEAT INTEGRATED RESTRAINTS (SIR)

Removal
1. Remove the affected seat.







2. Remove the seat adjuster control knobs, covers and the seat side trim panel screws.
1 Remove the seat recliner lever cover screw and cover.
2 Pull to remove the lumbar control knob.
3 Remove the 3 seat side trim panel attachment screws.







3. Remove the 2 screws securing the lumbar adjuster control to the seat track riser.
- Push the lumbar adjuster control inward to provide clearance for trim panel removal.

4. Pull the rearward lower corner of the side shield to disengage the metal retaining clip.

5. CAUTION: Bend the side shield slightly to make sure the shield is not scratched by the recliner lever.

Remove the side trim cover.







6. Disconnect the heated seat switch electrical connector. Press the locking tabs and remove the switch from the trim panel.

Installation







1. Install the heated seat switch into the trim panel and connect the heated seat switch electrical connector.
- Verify the switch locking tabs are securely seated.







2. CAUTION: Bend the side shield slightly to make sure the shield is not scratched by the recliner lever.

Position the side trim cover and install the 3 trim cover screws.
- The seat backrest pivot bolt shaft must be inserted into the cover standoff.

3. Push the rearward lower corner of the side shield to engage the metal retaining clip.







4. Position the lumbar adjuster control and install the 2 mounting screws. Install the adjuster knob.







5. Position the seat back recliner lever cover and install the screw.
6. Install the front seat.