Seat Control Switch - With Seat Integrated Restraints (SIR)

SEAT CONTROL SWITCH - WITH SEAT INTEGRATED RESTRAINTS (SIR)

Removal
1. Remove the affected seat.







2. Remove the seat adjuster control knobs, covers and the seat side trim panel screws.
1 Remove the seat recliner lever cover screw and cover.
2 Pull to remove the lumbar control knob.
3 Remove the 3 seat side trim panel attachment screws.







3. Remove the 2 screws securing the lumbar adjuster control to the seat track riser.
- Push the lumbar adjuster control inward to provide clearance for trim panel removal.

4. Pull the rearward lower corner of the side shield to disengage the metal retaining clip.

5. CAUTION: Bend the side shield slightly to make sure the shield is not scratched by the recliner lever.

Remove the side trim cover.







6. Disconnect the seat control switch electrical connector.







7. Remove the 2 screws on the seat control switch.

Installation







1. Position the seat control switch and install 2 screws.







2. Connect the seat control switch electrical connector.







3. NOTE: Bend the side shield slightly to make sure the shield is not scratched by the recliner lever.

Position the side trim cover. Install the 3 trim cover screws.
- The seat backrest pivot bolt shaft must be inserted into the cover standoff.

4. Push the rearward lower corner of the side shield to engage the metal retaining clip.







5. Position the lumbar adjuster control. Install the 2 mounting screws. Install the adjuster knob.







6. Position the seat back recliner lever cover. Install the screw.
7. Install the front seat.