Seat - Front, 20 Percent
SEAT-FRONT, 20 PERCENTRemoval
NOTE: New bolts must be installed, do not reuse the bolts that were removed.
1. Remove the front seats.
2. Remove and discard the 20 percent seat riser-to-floor RH rear bolt.
3. Remove the 20 percent seat riser-to-floor LH rear nut.
4. Remove the seat.
Installation
1. Position the seat.
2. Position the safety belt anchor. Install the 20 percent seat riser-to-floor LH rear nut.
- Make sure the safety belt is not twisted prior to installation
- Tighten to 55 Nm (41 lb-ft).
3. Install the new 20 percent seat riser-to-floor RH rear bolt.
- Tighten to 55 Nm (41 lb-ft).
4. Install the front seats.
5. Make sure the safety belt and buckles are accessible to the occupants after installation.