Fog/Driving Lamp: Service and Repair

FOG LAMP







Removal and Installation

NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

1. If equipped, remove the front license plate frame.
2. Remove the 3 fog lamp bracket bolts and the fog lamp and bracket assembly.
- Disconnect the electrical connector.
- To install, tighten to 5 Nm (44 lb-in).

3. Remove the fog lamp adjustment bolt.
4. Remove the 2 fog lamp pin-type retainers.
5. Pull outward on the retaining tabs and remove the fog lamp.
6. To install, reverse the removal procedure.
- If necessary, adjust the fog lamps.