Headlamp: Service and Repair

HEADLAMP ASSEMBLY

Aerodynamic:

Sealed Beam:

Removal and Installation

NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

Aerodynamic
1. Remove the 4 radiator grille screws.
2. Remove the 4 screws and the headlamp assembly.
- Disconnect the electrical connectors.

Sealed beam
3. Remove the side lamp/front turn signal lamp.
4. Remove the 4 screws and the headlamp retaining ring.
5. Remove the headlamp assembly.
- Disconnect the electrical connector.

All vehicles
6. To install, reverse the removal procedure.