Manual Control Lever Shaft and Seal

Manual Control Lever Shaft and Seal

Special Tool(s):

Removal
1. With the vehicle in NEUTRAL, position on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the selector lever cable end.





3. Remove the transmission fluid pan, gasket and filter.

4. NOTE: The pin should be driven up through the manual lever.

Remove and discard the manual valve detent lever shaft retaining pin.





5. Using the special tool, remove the manual valve detent lever shaft retaining pin.





6. CAUTION: Be careful not to damage the manual control lever bore.

Remove the manual control lever shaft assembly.





7. Using the special tool, remove the manual control lever seal and discard.





Installation

1. NOTE: Prior to installing the manual control lever seal, clean the bore opening with mineral spirits.

Using the special tool, install the manual control lever seal.





2. Loosen the 2 bolts on the transmission range (TR) position sensor.





3. Install the manual control lever shaft.





4. NOTE: Leave a small portion of the pin exposed.

Install the manual valve detent lever shaft retaining pin into the case.





5. NOTE: When the retaining pin is installed correctly, 2 mm (0.08 inch) of the pin will be exposed.

Install a new manual valve detent lever shaft retaining pin.





6. Tighten the 2 bolts to 10 Nm (89 inch lbs.).





7. Install the transmission fluid pan, gasket and filter.
8. Connect the selector lever cable end.





9. Adjust the shift linkage. Verify that the vehicle starts in PARK and NEUTRAL and the reverse lamps illuminate in REVERSE.