Crankshaft Position Sensor: Service and Repair

CRANKSHAFT POSITION (CKP) SENSOR







Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.

2. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.

Turn the ignition switch to the OFF position.







3. NOTE: The crankshaft position (CKP) sensor is located underneath the air conditioning compressor.

Remove the nut and position the positive battery cable and support bracket aside.
- To install, tighten to 30 Nm (22 lb-ft).

4. Remove the stud bolt and position the battery negative cable aside.
- To install, tighten to 47 Nm (35 lb-ft).







5. Disconnect the CKP sensor electrical connector.
6. Remove the bolt, the CKP sensor and discard the O-ring seal.
- To install, tighten to 13 Nm (10 lb-ft).

7. NOTE: Apply clean engine oil to the O-ring seal prior to installation.

To install, reverse the removal procedure.
- Install a new O-ring seal.