Gear Sensor/Switch: Service and Repair
Gearmotor Encoder AssemblyMaterial:
Removal and Installation
1. Set the mode select switch to the 4 HIGH (4H) position.
2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
3. Disconnect the gearmotor encoder assembly harness connectors.
4. Remove the 3 gearmotor encoder bolts and the gearmotor encoder assembly.
^ To install, tighten to 20 Nm (15 ft. lbs.).
5. Remove the grease from the motor adapter and check for any nicks or burrs. If any damage is found, repair or install a new adapter as necessary.
6. To install, reverse the removal procedure.
^ Apply a coat of grease to the new motor adapter.