Stabilizer Bar Link

Stabilizer Bar Link

Stabilizer Bar Link:

Removal and Installation

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. They must be replaced with the same part number or an equivalent part if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

1. Remove the stabilizer bar link lower nut and bushing.
^ Discard the nut.
^ To install, tighten to 80 Nm (59 ft. lbs.).
2. Remove and discard the stabilizer bar link upper nut, bolt and washer.
^ To install, tighten to 150 Nm (111 ft. lbs.).
3. Remove the stabilizer bar link.
4. To install, reverse the removal procedure.