Wheel Studs - Dual Rear Wheel (DRW)

Wheel Studs - Dual Rear Wheel (DRW)

Special Tool(s):

Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Using the special tool, remove and discard the wheel stud.





Installation
1. Position the new wheel stud aligning the serrations in the wheel extension made by the original wheel stud.





2. Place 4 washers over the outside end of the wheel stud and thread a standard wheel nut with the flat side against the washers. Tighten the wheel nut until the wheel stud seats against the back side of the wheel extension.





3. Remove the wheel nut and washers.