Seat Backrest Cover - Front

SEAT BACKREST COVER - FRONT

Removal and Installation

1. NOTE: Install a new crown washer when re-installing the armrest.

Remove the armrest.
1 Release the hook-and-loop at the rear of the armrest trim cover and access the armrest bolt.
2 Remove the armrest bolt and crown washer.
- To install, tighten to 35 Nm (26 lb-ft).

3 Remove the armrest.







2. Remove the backrest trim cover.
1 Release the J-clip at the bottom of the backrest.

2 CAUTION: Use care when separating the seat backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the seat backrest foam pad.

Invert the trim cover up the backrest, separate the hook-and-loop strips and remove the backrest trim cover.







3. To install, reverse the removal procedure.