Seat Cushion Cover - Rear, Bench
SEAT CUSHION COVER - REAR, BENCHExploded View
Seat Backrest - 3-Passenger Bench (Part 1):
Seat Backrest - 3-Passenger Bench (Part 2):
Seat Cushion - 3-Passenger Bench (Part 1):
Seat Cushion - 3-Passenger Bench (Part 2):
Seat Backrest - 4-Passenger Bench (Part 1):
Seat Backrest - 4-Passenger Bench (Part 2):
Seat Cushion - 4-Passenger Bench:
Removal and Installation
1. NOTE: RH shown, LH similar.
If equipped, insert an appropriate tool and release the detachable safety belt anchor(s) from the seat.
2. NOTE: The seat mounting latches are serviced as part of the bench seat risers. If either seat mounting latch is damaged and cannot be released to remove the seat, remove the seat latch striker with the seat attached.
Pull the 2 seat latch release straps and remove the rear seat.
3. Remove the 10 bolts and 2 risers from the seat cushion frame.
- To install, tighten to 51 Nm (38 lb-ft).
4. Release all the backrest trim cover rear J-clips and remove the inner cardboard panel from the backrest.
5. Release the cushion trim cover rear J-clips and access the safety belt retractor anchor bolt.
6. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
Remove the center safety belt anchor bolt(s) and route the safety belt anchor(s) through the seat cushion opening.
- To install, tighten to 75 Nm (55 lb-ft).
7. Release the 2 cushion trim cover J-clips at the rear corners.
8. Release all the remaining cushion trim cover J-clips.
9. Remove the 2 backrest-to-cushion rear bolts.
- If 4-passenger bench seat, remove the 4 backrest-to-cushion rear bolts.
- To install, tighten to 51 Nm (38 lb-ft).
10. Access and remove the 4 backrest-to-cushion outboard bolts.
- To install, tighten to 75 Nm (55 lb-ft).
11. Separate the cushion and backrest frames.
12. Invert the cushion trim cover to the row of retainers.
13. CAUTION: Use care not to tear the foam pad when releasing the cushion trim cover retainers.
Separate the row of retainers and remove the cushion trim cover.
- Route the safety belt buckle through the cushion trim cover opening.
14. To install, reverse the removal procedure.
- Make sure the safety belts and buckles are accessible to the occupants after installation.