Electronic Brake Control Module: Service and Repair

Anti-Lock Brake System (ABS) Module





Removal and Installation

All vehicles
1. Disconnect the battery ground. For additional information, refer to Battery.
2. Remove the 3 bolts and position the degas bottle aside.
^ To install, tighten the bolts to 10 Nm (89 lb-in).





Vehicles equipped Hydro-Boost(R)
3. Remove the air cleaner. For additional information, refer to Fuel Delivery and Air Induction.

All vehicles
4. Disconnect the ABS module electrical connector.
^ Release the lock tab.
^ Pull the connector from the module.





5. Remove the 4 screws and the ABS module.
^ To install, tighten the screws to 5 Nm (44 lb-in).
6. To install, reverse the removal procedure.
^ For vehicles with roll stability control (RSC), calibrate the ABS module. Follow the scan tool directions. Clear the DTCs. Carry out the self test with the brakes not applied.