4R70E/4R75E - Automatic Transaxle/Transmission

Transmission Insulator and Retainer

Transmission Insulator and Retainer:

Removal
1. Raise and support the vehicle.
2. Remove the 2 nuts.





3. Position a high-lift transmission jack under the transmission.
4. Raise the transmission until the retainer studs are separated from the transmission support crossmember.





5. Remove the bolts and the insulator and retainer.





Installation
1. Install the insulator and retainer and install the bolts.
^ Tighten to 90 Nm (66 lb-ft).





2. Lower the transmission while aligning the retainer studs with the holes in the crossmember. Allow the full weight of the transmission to rest on the crossmember.





3. Remove the high-lift transmission jack.
4. Install the insulator and retainer to crossmember nuts.
^ Tighten to 90 Nm (66 lb-ft).





5. Remove the supports and lower the vehicle.