Turbine Shaft Speed (TSS) Sensor and Intermediate Shaft Speed Sensor
Torqshift - Automatic Transaxle/TransmissionTurbine Shaft Speed (TSS) Sensor and Intermediate Shaft Speed Sensor
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Install a suitable high-lift transmission jack.
3. Remove the 2 wire harness retainers from the rear crossmember and position the wire harness aside.
4. Remove the 2 LH crossmember nuts.
5. Remove the LH crossmember bracket.
6. Remove the 2 RH crossmember nuts.
7. Remove the RH crossmember bracket.
8. Lower the transmission enough to gain access to the turbine shaft speed (TSS) sensor and intermediate shaft combination speed sensor.
9. Disconnect the TSS and intermediate shaft combination speed sensor electrical connector.
10. NOTE: Prior to removing the speed sensor, make sure that the area around the sensor is free of foreign material to prevent contamination of the transmission.
Remove the TSS and intermediate shaft combination speed sensor.
1) Remove the bolt.
2) Remove the TSS and intermediate shaft combination speed sensor.
Installation
1. Install the TSS and intermediate shaft combination speed sensor.
1) Lubricate the O-ring with clean transmission fluid and install the TSS and intermediate shaft combination speed sensor.
2) Install the bolt.
^ Tighten to 9 Nm (80 lb-inch).
2. Connect the TSS and intermediate shaft combination speed sensor electrical connector.
3. Raise the transmission and crossmember in position.
4. Install the LH crossmember bracket.
5. Install the 2 LH crossmember bracket nuts.
^ Tighten to 81 Nm (60 lb-ft).
6. Install the RH crossmember bracket.
7. Install the 2 RH crossmember bracket nuts.
^ Tighten to 81 Nm (60 lb-ft).
8. Install the wire harness and install the 2 retaining clips to the rear of the crossmember.
