Seat Backrest - Rear, Bucket
SEAT BACKREST - REAR, BUCKETRemoval and Installation
1. Insert an appropriate tool into the slot and release the detachable safety belt anchor from the seat.
2. Remove the seat.
- Pull the seat latch release handle, slide the seat to the right and disengage from the seat latch striker.
3. NOTE: The anti-rotation tab must be correctly aligned for correct installation.
Remove the bolt and detachable safety belt buckle.
- To install, tighten to 40 Nm (30 lb-ft).
4. Remove the RH armrest.
- Release the hook-and-loop at the rear of the armrest trim cover and partially invert to access the armrest bolt.
- Remove the armrest bolt and armrest.
- To install, tighten to 35 Nm (26 lb-ft).
- Remove the shim.
- To install, position the shim to the armrest stop post.
5. Remove the 3 screws and LH cushion side shield.
6. Remove the backrest pivot bolt.
- To install, tighten to 25 Nm (18 lb-ft).
7. WARNING: Use care when the seat back frame is removed and when releasing the recliners from a backrest upright position. The recliners are spring-loaded, which may cause the recliner upper arms to fold with significant speed/force. Failure to follow this instruction may result in serious personal injury.
Remove the 2 recliner-to-backrest bolts.
- To install, tighten to 48 Nm (35 lb-ft).
8. Lift and slide the backrest from the recliner and remove.
9. To install, reverse the removal procedure.