Seat Cushion - Front

SEAT CUSHION - FRONT

Disassembly and Assembly

WARNING:
- Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.
- To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Remove the seat.
2. Remove the seat backrest.
3. Remove the seat cushion.

4. NOTE: Note the wiring harness pin-type retainer locations for assembly.

Remove the power seat wiring assembly from the seat cushion.

5. Remove the cushion trim cover.
1 Release all cushion trim cover J-clips.
2 Remove the cushion frame from the cushion foam pad and cushion trim cover.
3 Separate the hook-and-loop strips and remove the cushion trim cover.







6. To assemble, reverse the disassembly procedure.