Seat Recliner - Front

SEAT RECLINER - FRONT

Removal and Installation

WARNING:
- Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.
- To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.
- Use care when the seat back frame is removed and when releasing the recliners from a backrest upright position. The recliners are spring-loaded, which may cause the recliner upper arms to fold with significant speed/force. Failure to follow this instruction may result in serious personal injury.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Remove the seat.
2. Remove the seat backrest.
3. Release the J-clip at the bottom of the backrest and partially invert the trim cover to access the recliner bolts.
4. Remove the 2 bolts and recliner.
- To install, tighten to 48 Nm (35 lb-ft).







5. To install, reverse the removal procedure.